8 9
ninjakitchen.com
1 Place the brewer on a dry, clean, and
level surface. Plug your brewer in and
power it on.
2 Remove the water reservoir from the
unit by lifting it straight up (Fig� 1).
Remove the lid entirely and fill the water
reservoir to the desired level (Fig� 2).
NOTE: DO NOT fill past the 12-Cup Line.
If overfilled, remove the water reservoir
from the brewer and pour out water until
the level is no higher than the 12-Cup Line.
3 Place the filter holder in the brew basket
(Fig� 3). Then place the permanent filter or
a #4 paper filter in the filter holder.
NOTE: If using a paper filter, fold the
paper filter along the seams, open it fully,
and firmly press it into the filter holder,
making sure it is fully seated.
Fig. 1
Fig. 3
4 Add your desired amount of coee
grounds to the brew basket.
5 Place the brew-through lid on the
carafe and turn clockwise to lock into
place (Fig� 4). Then place carafe under
the brew basket (Fig� 5).
6 Select either CLASSIC or RICH brew.
If you are brewing 4-cups or less, also
select SMALL BATCH. (Fig� 6).
7 Press BREW to start brewing. When the
brewing is complete, the unit will beep.
NOTE: Each brew has a pre-infusion cycle
with varying times. The brew will begin, pause
for a short period of time, and then continue
brewing. This pre-infusion cycle is used to
evenly saturate the coee grounds.
Integrated Ninja Scoop
is equivalent to 1 tbsp. of coee.
Fig. 2
Fig. 5
Fig. 4
Fig. 6
HOW TO BREW PREPARING & USING YOUR NINJA® COFFEE BREWER
Integrated Ninja® Scoop
BATCH SIZE CUPS OF COFFEE GROUNDS WATER
Small Batch
(SMALL BATCH button on)
2 cups 2 Ninja Scoops or 2 tbsp. 2-cup line
4 cups 4 Ninja Scoops or 4 tbsp. 4-cup line
Full Carafe
(SMALL BATCH button o)
6 cups 6 Ninja Scoops or 6 tbsp. 6-cup line
8 cups 8 Ninja Scoops or 8 tbsp. 8-cup line
10 cups 10 Ninja Scoops or 10 tbsp. 10-cup line
12 cups 12 Ninja Scoops or 12 tbsp. 12-cup line
COFFEE MEASUREMENT CHART
ENGLISH
To Next Page
Loading...
Need help?
General
