Learn more at BNX.com
FITTING INSTRUCTIONS:
PERFORMING A SEAL CHECK:
It is necessary to perform a seal check on the
respirator
every
time you wear it.
Cup both hands around the
respirator
and inhale and exhale
forcefully several times. If you notice any air leakage, adjust the
nosepiece and headbands until the leakage is corrected. Pull the
headbands back, up, or, if necessary, shorten them by knotting. Once
corrected, repeat the seal check again.
WARNING The respirator should not be used without a
proper fit. This respirator helps protect against certain
contaminants. It may not eliminate the risk of contracting disease or
infection. Misuse may result in sickness or death.
Materials which may come into contact with the wearer’s skin could
cause allergic reactions to susceptible individuals.
Manufactured by
BNX Converting, LLC.
16727 Park Row Houston, TX 77084 USA
Unfold the respirator and allow the
headbands to hang outward on both sides.
Position the respirator on your face with the
adjustable metal nosepiece facing up.
Test the seal by cupping both hands over the
protective respirator . Then, begin to inhale
and exhale sharply. If air leaks around the
respirator’s edges, adjust the straps and
reposition the nose piece until a proper seal
is formed.
Using both hands, press down on the metal
nosepiece to form a tight-fitting seal around
your nose.
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Pull the headbands over your head. Place
the bottom band below the ears and the top
band on the crown of your head.
To Previous Page
Loading...
