Chapter 3 Installation and set up
000191-16 NIOX VERO
®
User Manual English 7
(N) Breathing handle holder, (O) Breathing handle port
3 Installation and set up
Open the package with care. Prior to installation, check that the package
contains all the parts (see section 2.1). A screwdriver is required for opening
the compartment lid and installation of sensor and battery. Remove the plastic
film from the display.
1. Carefully place the instrument with the display facing down on a flat and
clean surface, then unscrew and remove the compartment lid. There is a
taper on the side of the lid for better grip when opening.
2. Open the sensor can.
To Next Page
