The passenger side switch will open or close
only the corresponding window. To open or
close the window, hold the switch down or up.
Locking passenger’s windows
When the lock button is pushed in, only the
driver side window can be opened or closed.
Push it in again to cancel.
Automatic operation
To fully open or close the driver’s side window,
completely press or lift the switch and release
it; it need not be held. The window will auto-
matically open or close all the way. To stop the
window, just press the switch on the opposite
side.
Auto reverse function (For driver’s
window)
If the control unit detects something caught in
the driver’s window as it moves up, the window
will be immediately lowered.
The auto reverse function can be activated
when the driver’s window is closed by auto-
matic operation when the ignition key is in the
ON position or for about 45 seconds after the
ignition key is turned to the OFF position.
I Depending on the environment or driv-
ing conditions, the auto reverse function
may be activated if an impact or load
similar to something being caught in the
window occurs.
WARNING
There are some small distances imme-
diately before the closed position which
cannot be detected. Make sure that all
passengers have their hands, etc., in-
side the vehicle before closing the win-
dow.
SIC0627B SPA0980
2-28 Instruments and controls
Z 00.1.17/A33-D/V5.0 X
To Next Page