transmitter to HomeLink , continue to press
and hold the HomeLink
button (note steps 2
through 4 under “Programming HomeLink
”)
while you press and re-press (“cycle”) your
hand-held transmitter every 2 seconds until
the indicator light flashes rapidly (indicating
successful programming).
NOTE:
If programming a garage door opener, etc.,
it is advised to unplug the device during
the “cycling” process to prevent possible
damage to the garage door opener compo-
nents.
OPERATING THE INTEGRATED
HomeLink
UNIVERSAL
TRANSCEIVER
The Integrated HomeLink Universal Trans-
ceiver (once programmed) may now be used
to activate the garage door, etc. To operate,
simply press the appropriate programmed In-
tegrated HomeLink
Universal Transceiver
button. The red indicator light will illuminate
while the signal is being transmitted.
PROGRAMMING
PROBLEM-DIAGNOSIS
If the HomeLink does not quickly learn the
hand-held transmitter information:
I replace the hand-held transmitter batteries
with new batteries.
I position the hand-held transmitter with its
battery area facing away from the
HomeLink
surface.
I press and hold both the HomeLink
and
hand-held transmitter buttons without inter-
ruption.
I position the hand-held transmitter 2 to 5
inches (50 to 127 mm) away from the
HomeLink
surface. Hold the transmitter in
that position for up to 15 seconds. If
HomeLink
is not programmed within that
time, try holding the transmitter in another
position - keeping the indicator light in view
at all times.
If you continue to have programming difficul-
ties, please contact the NISSAN Consumer
Affairs Department. The phone numbers are
located in the Foreword of this Owner’s
Manual.
CLEARING THE PROGRAMMED
INFORMATION
Individual buttons cannot be cleared, however
to clear all programming, press and hold the
two outside buttons and release when the
indicator light begins to flash (approximately
20 seconds).
ROLLING CODE PROGRAMMING
Rolling code garage door openers (or other
rolling code devices) which are “code pro-
tected” and manufactured after 1996, may be
determined by the following.
A. Reference the garage door opener Owner’s
Manual for verification.
B. The hand-held transmitter appears to pro-
gram the Integrated HomeLink
Universal
Transceiver but does not activate the ga-
rage door.
C. Press and hold the trained HomeLink
but-
ton. If the garage door opener has the
rolling code feature, the HomeLink
indica-
tor light will flash rapidly, then remains on
after 2 seconds.
To program the Integrated HomeLink
Univer-
sal Transceiver to a garage door opener with
the rolling code feature, follow these instruc-
tions after completing the “Programming
HomeLink
” (the aid of a second person may
make the following procedures quicker and
easier).
1. Locate the training button on the garage
door opener motor unit. Exact location and
Instruments and controls 2-35
Z 00.1.17/A33-D/V5.0 X
To Next Page
Loading...