To view detailed instructional videos regarding these and other features,
please go to www.nissanownersinfo.mobi.
28
FOG LIGHT SWITCH (if so equipped)
In order to operate the fog lights, you must have
your headlights on with the low beams selected.
Turn the switch (inside collar) to the
position
6
to turn the fog lights on.
Turn the switch (inside collar)
to the OFF position to turn the fog lights o.
LANE CHANGE SIGNAL
Move the lever up or down until the turn signal begins to ash but the lever
does not latch to signal a lane change. Hold the lever until the lane
change is completed.
Move the lever up or down until the turn signal begins to ash but the lever
does not latch and release the lever. The turn signal will automatically
ash three times.
Choose the appropriate method to signal a lane change based on road and
trac conditions.
Please see your Owner’s Manual for important safety information, system limitations, and additional
operating and feature information.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
WIPER AND WASHER SWITCH
Move the lever to one of the following
positions to operate the windshield wipers:
1
Mist (MIST) – This is a one-sweep
operation of the front wipers.
2
Intermittent (INT) – Front wipers
operate intermittently by moving the
lever down to the INT position and then
rotating the control ring
3
to increase
or decrease INT wiper speed.
Also, the intermittent operation speed
varies in accordance to the vehicle speed.
4
Low (LO) – Front wipers operate at a
continuous low-speed.
5
High (HI) – Front wipers operate at a
continuous high-speed.
6
Front washer – Pull the lever toward you to activate the front washer.
The front wipers will operate several times.
DRIP WIPE
Once the wiper spray cycle is nished, there will be a short delay. Then the
wipers will sweep one more time to clear o any remaining drips
from the windshield.
3
1
2
4
5
MIST
OFF
INT
LO
HI
6 9
6
2948550_18a_Leaf_QRG_100317.indd 28 10/3/17 3:58 PM
To Next Page
Loading...