[ Edit: 2016/ 11/ 24 Model: E12-A ]
1-20 Safety — seats, seat belts and supplemental restraint system
SSS0757A
Step 6
6. Test the child restraint before you place the child
in it
*
5
. Push the child restraint from side to side
and tug it forward to make sure that it is held
securely in place.
7. Check to make sure that the child restraint is
properly secured prior to each use. If the child
restraint is loose, repeat steps 3 through 6.
CHILD RESTRAINT INSTALLATION USING
SEAT BELT
GUID-BF053DAC-D4D8-4641-959B-8DA54D2C2679
Installation on rear seats - seat belts without
automatic locking mode
GUID-D827F3E0-8DA3-4B51-B23D-0FB5EF0EC3B4
WARNING:
. The three-point type seat belt on your
vehicle is not equipped with an automatic
locking mode retractor.
. The direction of the child restraint system
depends on the type of the child restraint
system and the size of the child.
Front-facing:
GUID-11F97BB9-9503-47D0-8BB9-62C812293875
SSS0374A
If you must install a front-facing child restraint system
on the rear seat, follow these steps:
1. Position the front-facing child restraint system on
the rear seat.
Always follow the child restraint system manufac-
turer’s instructions for installation and use.
2. Route the seat belt tongue through the child
restraint system and insert it into the buckle until
you hear and feel the latch engage.
SSS0513
To prevent slack in the lap belt, it is necessary to
secure the shoulder belt in place with a locking
clip
*
A
. Use the locking clip attached to the child
restraint system or one which is equivalent in
dimension and strength.
Be sure to follow the child restraint system
manufacturer’s instructions for belt routing.
3. Test the child restraint system before you place
the child in it. Tilt it from side to side. Try to tug it
forward and check if it is held securely in place.
4. Make sure that the child restraint system is
properly secured prior to each use.
Rear-facing:
GUID-11F97BB9-9503-47D0-8BB9-62C812293875
SSS0375A
If you must install a rear-facing child restraint system
on the rear seat, follow these steps:
1. Position the rear-facing child restraint system on
the rear seat.
Always follow the child restraint system manufac-
turer’s instructions for installation and use.
2. Route the seat belt tongue through the child
restraint system and insert it into the buckle until
you hear and feel the latch engage.
Condition:
To Next Page
Loading...