[ Edit: 2016/ 11/ 24 Model: E12-A ]
2-24 Instruments and controls
Automatic function
E12-A-120227-E32069C0-BAE6-4271-BCF2-D8434F16F2FC
SIC4405
Automatic function is available for the switch that has
an
mark on its surface.
The automatic function enables a window to fully open
or close without holding the switch down or up.
To fully open the window, push the power window
switch down to the second detent and release the
switch. To fully close the window, pull the power
window switch up to the second detent and release
the switch. The switch does not have to be held during
window operation.
To stop the window open/close operation during the
automatic function, push down or pull up the switch in
opposite directions.
Window timer (if equipped):
GUID-11F97BB9-9503-47D0-8BB9-62C812293875
The window timer allows the driver’s window to be
operated for approximately 15 minutes even if the
ignition switch is pushed to the “ACC”, “OFF” or
“LOCK” position. The window timer will be cancelled
when the corresponding door is opened and closed, or
the preset time has been exceeded.
Auto-reverse function:
GUID-11F97BB9-9503-47D0-8BB9-62C812293875
WARNING:
There is a small distance just before the closed
position which cannot be detected. Make sure
that all passengers have their hands, etc. inside
the vehicle before closing the windows.
The auto-reverse function enables a window to
automatically reverse when something is caught in
the window as it is closing by the automatic function.
When the control unit detects an obstacle, the window
will be lowered immediately.
Depending on the environment or driving conditions,
the auto-reverse function may activate if an impact or
load similar to something being caught in the window
occurs.
When power window switch does not oper-
ate
E12-A-120227-955BEF18-311C-4AF0-8E6C-BE60F57D555F
Some power window functions (automatic close
function, auto-reverse function) will not operate as
described after the battery cable is disconnected and
the electrical supply is interrupted. Perform the
following procedure to initialize the power window
functions.
1. Place the ignition switch in the "ON" position.
2. If the driver’s window is closed, open it completely
by operating the driver’s window switch.
3. Pull up and hold the driver’s window switch to
close the driver’s window. Hold the switch for
approximately 3 seconds after the window has
been fully closed, and then release it.
4. Check if the power window functions operate
properly.
If you open or close the power window continuously, it
may cause the power window not to operate properly.
Perform the above procedure.
If the power window functions do not operate properly
after performing the above procedure, repeat the
steps. See a NISSAN dealer, if necessary, for checking
the power window system.
Condition:
To Next Page
Loading...