3. Push the temperature control “ ”/“ ” but-
ton to set the desired temperature.
4. If the indicator light on either the outside air cir-
culation “
” button or the air recirculation
“
” button is illuminated, push and hold the
button with the light illuminated to switch to the
automatic air intake control mode. (The indicator
light will blink twice.)
A visible mist may be seen coming from the vents in
hot, humid conditions as the air is cooled rapidly.
This does not indicate a malfunction.
Heating (A/C off):
1. Push the “AUTO” button. (“AUTO” will appear
on the display.)
2. If the “A/C” indicator light illuminates, push the
“A/C” button. (The “A/C” indicator light will turn
off.)
3. Push the temperature control “
”/“ ” but-
ton to set the desired temperature.
•
Do not set the temperature lower than the out-
side air temperature. Doing so may cause the
temperature to not be controlled properly.
•
If the windows fog up, use dehumidified heating
instead of the A/C off heating.
Dehumidified defrosting/defogging:
1. Push the front defogger “
” button. (The
“
” indicator light will illuminate.)
2. Push the temperature control “ ”/“ ” but-
ton to set the desired temperature.
•
To remove frost from the outside surface of the
windscreen quickly, set the temperature to a high
temperature and the fan speed to the maximum
level.
•
After the windscreen is cleared, push the front
defogger “
” button again. (The indicator
light will turn off.)
•
When the front defogger “ ” button is
pushed, the air conditioner will automatically turn
on when the outside air temperature is above
−2°C (28°F) to defog the windscreen. The air
recirculation mode will automatically turn off. The
outside air circulation mode “
” will be se-
lected to improve the defogging performance.
Manual operation
The manual mode can be used to control the heater
and air conditioner to your desired settings.
(“MANUAL” will appear on the display.)
To turn off the heater and air conditioner, push the
“OFF” button.
Fan speed control:
Push the fan speed control “
”/“ ” button.
Push the “
” button to increase the fan speed.
Push the “
” button to decrease the fan speed.
Push the “AUTO” button to change the fan speed to
the automatic mode.
Air flow control:
Push the “MODE” button to change the air flow
mode.
m
Air flows from the centre and side
vents.
m
Air flows from the centre and side vents
and foot outlets.
m
Air flows mainly from the foot outlets
m
Air flows from the defogger outlets and
foot outlets.
Temperature control:
Push the temperature control “
”/“ ” button
to set the desired temperature. Push the “
”
button to increase the temperature. Push the “
”
button to decrease the temperature.
Outside air circulation:
Push the outside air circulation “
” button to
draw the air flow from outside the vehicle. (The
“
” indicator light will illuminate.)
Air recirculation:
Push the air recirculation “
” button to circulate
the air flow inside the vehicle. (The “
” indicator
light will illuminate.)
Automatic air intake control:
If the indicator light on either the outside air circula-
tion “
” button or the air recirculation “ ”
button is illuminated, push and hold the button with
the light illuminated. (The indicator light will blink
twice.) The automatic air intake control mode is set.
4-18 Heater and air conditioner, and audio system
To Next Page
Loading...