– If the wrong code is entered after eight sets
of three entries, the audio unit will lock per-
manently. Contact a NISSAN dealer for fur-
ther details.
AUDIO MAIN OPERATION
The audio unit operates when the ignition switch is
in ACC or ON position.
m
Power ON/OFF button
Press the < > button to switch on the audio unit.
If the audio unit was switched off using the ignition
switch, it can also be switched on with the ignition
switch. The source that was playing immediately
before the unit was switched off will resume playing
and the volume will be set to the previous volume
level.
The audio unit can be switched off by pressing
<
>, or by turning the ignition switch to the “OFF”
or LOCK position.
Volume (VOL) level control
Turn the <VOL> dial clockwise or anticlockwise to
adjust the volume level.
The audio unit is equipped with a speed control vol-
ume function, this means that the audio system au-
tomatically adjusts the volume level in relation to
vehicle speed. For details, see “SETUP button” later
in this section.
Day/Night button
The illumination brightness level is linked to the
headlight switch. When the headlights are switched
on, the brightness is dimmed automatically. Press
the button to switch between daytime and nighttime
mode independent of headlamp status.
AUX button
The AUX IN socket is located on the opposite side
of the power outlet. The AUX IN audio socket ac-
cepts any standard analog audio input such as from
a portable cassette tape/CD player, MP3 player,
laptop computers, etc.
When the jack of a compatible audio device is
plugged into the AUX IN socket, press the <AUX>
button.
RADIO OPERATION
When the < > (power ON/OFF) button is
pressed, the audio unit will switch on with the last
received radio station, if the audio unit was previ-
ously switched off in radio mode.
Radio band select
buttons
Press the <FM•AM> button repeatedly to change
the reception wave band as follows:
FM1 → FM2 → FMT → AM → FM1
When <FM•AM> button is pressed, the radio will
come on at the last received radio station. If the CD
or AUX source mode is already playing, pressing
the <FM•AM> button will switch off the playing
source mode and the last received radio station will
be selected.
FM Auto store
When the <FM•AM> button is pressed for more
than 1.5 seconds the six stations with the strongest
frequencies are stored in the preset (1 to 6) buttons
of the FMT band. During the search, a notification
message [AUTOSTORE] appears in the display and
the sound is muted until the operation is complete.
Once completed, the radio selects preset button
j1.
Manual tuning
When adjusting the broadcasting station frequency
manually, turn the <TUNE/MENU> dial until the de-
sired station is tuned in.
The frequency increases or decreases in steps of
100 kHz on the FM band, and 9 kHz on the AM
band.
WARNING
The radio should not be tuned while driving in
order for full attention to be given to the driving
operation.
SEEK tuning buttons
Pressing the < > or < > button starts the tun-
ing mode. The radio tuner seeks from low to high or
high to low frequencies and stops at the next broad-
casting station. During seek mode, the audio output
4-28 Heater and air conditioner, and audio system
To Next Page
Loading...