is muted. If no broadcasting station can be found
within the complete band cycle, it will return to the
initial frequency.
Preset station buttons j1 j2 j3 j4 j5 j6
Pressing a preset button for less than 2 seconds will
select the stored radio station.
Pressing a preset button for more than 2 seconds
will cause the station currently being received to be
stored against that preset button.
•
Eighteen stations can be stored in the FM band.
(Six each for FM1, FM2 and FMT)
•
Six stations can be set for the AM band.
If the battery is disconnected, or if the fuse blows,
the radio memory will be erased. In that case, reset
the desired stations after battery connection or fuse
replacement.
Radio data system (RDS) operation
The RDS is a system through which encoded digital
information is transmitted by FM radio stations in
addition to the normal FM radio broadcasting. The
RDS provides information services such as station
name, traffic information, or news.
NOTE
In some countries or regions, some of these ser-
vices may not be available.
Alternative Frequency (AF) mode:
The AF mode operates in the FM (radio) mode.
•
The AF mode operates both in the FM (radio),
AUX or CD mode (if FM was previously selected
in the radio mode).
•
The AF function compares signal strengths and
selects the station with the optimum reception
conditions for the currently tuned-in station.
RDS functions
Programme Service (PS) function (station name
display function):
When an RDS station is tuned in with seek or manual
tuning, the RDS data is received and the PS name
is displayed.
TA Traffic announcement
This function operates in FM (Radio), CD or AUX
mode.
•
Pressing the <TA> button selects the TA mode.
The TA indicator is displayed while TA mode is
on.
•
When <TA> is pressed again. The mode will be
switched off and the TA indicator will disappear
from the display.
Traffic announcement interrupt function:
When a traffic announcement is received, the an-
nouncement is tuned in and the display shows a
notification message with the radio station name for
example [TA: Radio 1].
Once the traffic announcement has finished, the unit
returns to the source that was active before the traf-
fic announcement started.
If <TA> is pressed during a traffic announcement,
the traffic announcement interrupt mode is can-
celled. The TA mode returns to the standby mode
and the audio unit returns to the previous source.
SETUP BUTTON
To configure Audio, Clock, Bluetooth, Language or
Scroll direction settings, perform the following pro-
cedure:
1. Press the <SETUP> button.
2. Turn the <TUNE/MENU> dial clockwise or anti-
clockwise until the desired mode is displayed.
[Audio] ⇔ [Clock] ⇔ [Bluetooth] ⇔ [Language]
⇔ [Scroll Direction]
3. Press the <ENTER> button to confirm the selec-
tion.
After the desired levels have been set, press either
the <
> (Back) button repeatedly, the
<SETUP> button, or wait for 8 seconds without
pressing any buttons to exit the menu screen.
Audio adjustments
The [Audio] set up screen will appear when select-
ing the [Audio] item from the set up menu.
Heater and air conditioner, and audio system 4-29
To Next Page
Loading...