Vehicle information display:
jA
Set speed indicator
When the vehicle speed exceeds the set speed limit,
the set speed indicator blinks and the accelerator
pedal operation will not work until the vehicle speed
slows down to the set speed limit.
Instrument panel:
jB
Speed limiter indicator light
jC
SET indicator light
The speed limiter will not automatically brake the
vehicle to the set speed limit.
Turning on speed limiter
Push the speed limiter MAIN switch. The speed lim-
iter indicator light illuminates. The set speed indica-
tor shows “– – –”.
Setting speed limit
1. Push the SET/− switch.
•
When the vehicle is stopped, the speed will be
set at 30 km/h or 20 MPH.
•
While driving, the speed limit will be set at the
current speed.
2. When the speed limit is set, the SET indicator
and the set speed indicators illuminate on the
vehicle information display and instrument panel.
Changing set speed limit:
Use either of the following operations to change the
speed limit.
•
Push and hold the RES/+ or SET/− switch. The
set speed will increase or decrease by approxi-
mately 10 km/h or 10 MPH.
•
Push, then quickly release the RES/+ or SET/−
switch. Each time you do this, the set speed will
increase or decrease by approximately 1 km/h or
1 MPH.
Resuming preset speed limit:
Push the RES/+ switch. The SET indicator light illu-
minates, and the speed limiter will resume the last
set speed limit. If the vehicle is driven at a speed
over the last set speed limit, the set speed indicator
will blink.
Cancelling speed limit
To cancel the speed limiter, push the CANCEL
switch. The SET indicator light will turn off. (The set
speed indicator will remain on the display.)
If the accelerator pedal is fully depressed (beyond
the resistance point), the speed limiter is temporarily
suspended and the vehicle speed may be controlled
above the set speed. (The transmission may down-
shift into a lower gear). The SET indicator light will
remain on the meter panel.
If the accelerator pedal returns to the resistance
point and the vehicle speed returns to the set speed,
the speed limiter will activate and limit vehicle speed.
When one of the following operations is performed,
the speed limiter will be cancelled. The speed limiter
indicator light, and the SET indicator light will turn
off. These cancelling methods will erase the set
speed limit memory.
•
Push the speed limiter MAIN switch.
•
Push the cruise control MAIN switch.
Speed limiter malfunction
If the speed limiter malfunctions, the SET indicator
light on the instrument panel will blink. Turn the
speed limiter MAIN switch off and have the system
checked by a NISSAN dealer or qualified workshop.
5-24 Starting and driving
To Next Page
Loading...