1. Open the back door.
2. Raise the back door floor cover.
3. Remove the retainer
j1 by turning it anti-clock-
wise.
4. Remove the jack, necessary tools and the spare
wheel from the storage area.
If there are spacers around the spare wheel/tyre
at the storage location, remove it before remov-
ing the spare wheel/tyre.
Removing wheel cover (where fitted)
WARNING
Take care when removing the wheel cover as the
cover may detach suddenly.
Remove the wheel cover as illustrated with a suit-
able tool or carefully remove the wheel cover with
both hands.
Removing the wheel
WARNING
•
Make sure to read the caution label attached
to the jack body before use.
•
Make sure the parking brake is applied.
•
DO NOT GET UNDER A VEHICLE THAT IS
SUPPORTED BY A JACK.
•
Never use a jack which was not provided with
your vehicle.
•
The jack, which is provided with your vehicle
is designed only to lift your vehicle during a
wheel change.
•
Use the correct jack-up points. Never use any
other part of the vehicle for jack support.
•
Never lift the vehicle more than necessary.
•
Never use blocks on or under the jack.
•
Do not start or run the engine while the ve-
hicle is on the jack. The vehicle may move
suddenly, and this may cause an accident.
•
Never allow passengers to stay in the vehicle
while the wheel is off the ground.
•
Make sure to read the caution label attached
to the jack body before use.
•
Remove all loads before lifting the vehicle with
the jack.
SCE0913Z SCE0173AZ
JVE0056XZ
jack-up points
6-4 In case of emergency