Front head restraint:
1. Pull up the head restraint to raise.
2. Push in the lock knob
j1 and push down the
head restraint to lower.
Rear head restraint:
Use the rear head restraint in the notched stem po-
sitions after pulling it up to raise the rear head re-
straint.
NOTE
Pull up the rear head restraint to raise to the
proper position and make sure it is securely
locked before using the seating position. The rear
head restraint will not function properly if it is
used in the stowed position.
Removing and restoring:
1. Push and hold the lock knob
j1 and raise the
head restraint to remove.
2. To restore, push and hold the lock knob
j1 and
insert the head restraint.
PRECAUTIONS ON SEAT BELT
USAGE
If you are wearing the seat belt properly adjusted
and sitting upright and well back in the seat, chances
of being injured or killed in an accident and/or the
severity of injury may be greatly reduced. NISSAN
strongly encourages you and all of your passengers
to buckle up every time you drive, even if your seat-
ing position includes the supplemental air bag sys-
tems.
WARNING
•
Seat belts are designed to bear upon the bony
structure of the body, and should be worn low
across the front of the pelvis or the pelvis,
chest and shoulders, as applicable; wearing
the lap section of the belt across the abdomi-
nal area must be avoided. Serious injury may
occur if a seat belt is not worn properly.
SSS0136Z
SSS0134Z
SEAT BELTS
Safety — seats, seat belts and supplemental restraint system 1-7
To Next Page