Rear-facing:
Be sure to follow the manufacturer’s instructions for
the proper use of your child restraint. Follow these
steps to install a rear-facing child restraint on the
rear outboard seats using ISOFIX:
1. Position the child restraint on the seat
j1.
2. Secure the child restraint anchor attachments to
the ISOFIX lower anchors
j2.
3. Shorten the rigid attachment to have the child
restraint firmly tightened; press downward
j3
and rearward
j4 firmly in the centre of the child
restraint with your hand to compress the vehicle
seat cushion and seatback.
4. If the child restraint is equipped with a top tether
strap, route the top tether strap and secure the
tether strap to the tether anchor point. (See
“Child restraint anchorage” earlier in this
section
.)
5. If the child restraint is equipped with other anti-
rotation devices such as support legs, use them
instead of the top tether strap following the child
restraint manufacturer’s instructions.
6. Test the child restraint before you place the child
in it
j5 . Push the child restraint from side to side
and tug it forward to make sure that it is held
securely in place.
7. Check to make sure that the child restraint is
properly secured prior to each use. If the child
restraint is loose, repeat steps 3 through 6.
CHILD RESTRAINT INSTALLATION
USING SEAT BELT
Installation on rear seats - seat belts
without automatic locking mode
WARNING
•
The three-point type seat belt on your vehicle
is not equipped with an automatic locking
mode retractor.
•
The direction of the child restraint system de-
pends on the type of the child restraint sys-
tem and the size of the child.
Front-facing:
If you must install a front-facing child restraint sys-
tem on the rear seat, follow these steps:
1. Position the front-facing child restraint system on
the rear seat.
Always follow the child restraint system manu-
facturer’s instructions for installation and use.
NIC1926
Steps 1 and 2
SSS0756AZ
Step 3
SSS0757AZ
Step 6
SSS0374AZ
Safety — seats, seat belts and supplemental restraint system 1-23