[ Edit: 2012/ 4/ 9 Model: E26-A ]
Checking battery fluid level
GUID-0BF58C7C-A AD6-4FFC-94F1-3236F2DB1E42
DI0137MD
SDI1480D
Check the fluid level in each cell. The battery fluid level
should be between the UPPER LEVEL
*
1
and
LOWER LEVEL
*
2
lines.
If it is necessary to add fluid, add only demineralized/
distilled water to bring the level to the indicator in each
filler opening. Do not overfill.
1. Remove the cell plugs
*
3
(if equipped).
2. Add demineralized/distilled water up to the
UPPER LEVEL
*
1
line.
If the side of the battery is not clear, check the
distilled water level by looking directly above the
cell; the condition
*
A
indicates OK and the
condition
*
B
needs more to be added.
3. Replace and tighten the cell plugs.
. Vehicles operated in high temperatures or under
severe conditions require frequent checks of the
battery fluid level.
. Keep the battery surface clean and dry. Clean the
battery with a solution of baking soda and water.
. Make certain the terminal connections are clean
and securely tightened.
. If the vehicle is not to be used for more than 30
days, disconnect the negative (−) battery terminal
cable to prevent battery discharge.
Jump starting
GUID-12932DA0-25A5-4DC2-80E0-D33827D34EC3
If jump starting is necessary, see “Jump starting” (P.6-
7). If the engine does not start by jump starting or the
battery does not charge, the battery may have to be
replaced. Contact a NISSAN dealer for replacing the
battery.
REMOTE CONTROLLER BATTERY
GUID-55E9232D-C84B-4BD2-A9E1-14B9C881B4F4
Battery replacement
GUID-91A7C044-7A89-485F-953A-2D21893726C8
CAUTION:
. Be careful not to allow children to swallow
the battery and removed parts.
. An improperly disposed battery can harm
the environment. Always confirm local reg-
ulations for battery disposal.
. When changing batteries, do not let dust or
oil get on the components.
. There is danger of explosion if lithium
battery is incorrectly replaced. Replace only
with the same or equivalent type.
JVM0105X
To replace the battery:
1. Remove the screw
*
A
.
2. Insert a small screwdriver into the slit of the corner
*
B
and twist it to separate the upper part from
the lower part. Use a cloth to protect the casing.
3. Replace the battery with a new one.
Recommended battery: CR1620 or equivalent
.
Do not touch the internal circuit and electric
terminals as doing so could cause a malfunc-
tion.
Maintenance and do-it-yourself 8-21
To Next Page
Loading...