[ Edit: 2012/ 4/ 9 Model: E26-A ]
Auto-reverse function (if equipped):
GUID-896AA31A-81D 0-4E9B-81ED-1F58D53AA854
WARNING:
There is a small distance just before the closed
position which cannot be detected. Make sure
that all passengers have their hands, etc. inside
the vehicle before closing the windows.
The auto-reverse function enables a window to
automatically reverse when something is caught in
the window as it is closing by the automatic function.
When the control unit detects an obstacle, the window
will be lowered immediately.
Depending on the environment or driving conditions,
the auto-reverse function may activate if an impact or
load similar to something being caught in the window
occurs.
When power window switch does not oper-
ate
GUID-7A8CE0B5-B466-46D9-A628-8B674ED19714
Some power window functions (automatic close
function, auto-reverse function and window timer) will
not operate as described after the battery cable is
disconnected and the electrical supply is interrupted.
Perform the following procedure to initialize the power
window functions.
1. Turn the ignition switch to the "ON" position.
2. If the driver’s window is closed, open it completely
by operating the driver’s window switch.
3. Pull up and hold the driver’s window switch to
close the driver’s window. Hold the switch for
approximately 3 seconds after the window has
been fully closed, and then release it.
4. Check if the power window functions operate
properly.
If you open or close the power window continuously, it
may cause the power window not to operate properly.
Perform the above procedure.
If the power window functions do not operate properly
after performing the above procedure, repeat the
steps. See a NISSAN dealer, if necessary, for checking
the power window system.
SLIDING WINDOWS (if equipped)
GUID-5FBAFE9F-AEE0-458D-B21D-5EBA43B75A04
JVI0425X
To open the sliding window, squeeze the knob
*
1
and
slide the window open
*
2
toward the rear of the
vehicle.
To close, completely close the window until there is a
locking sound.
GUID-B3C271B4-0281-4A83-BF04-DFB2DABA7CCB
JVI0408X
The digital clock
*
1
displays the time when the
ignition switch is in the “ACC” or “ON” position.
If the battery cable is disconnected, the time displayed
on the clock will be reset and the correct time will not
be indicated.
For the clock adjustment in the audio unit (if equipped),
see “Audio system” (P.4-6).
ADJUSTING TIME
GUID-CC11B085-9563-4623-8D60-3DC34BC13729
To adjust the time, perform the following procedure.
1. Push the clock adjusting knob
*
2
for 3 seconds
or more to enter time adjust mode.
The hours display will start to flash.
2. Turn the clock adjusting knob
*
2
to adjust the
hour.
To advance the time, push the knob
*
2
.
The minute display will start to flash.
3. Turn the clock adjusting knob
*
2
to adjust the
minutes.
To return to the initial display screen, push the
knob
*
2
.
Instruments and controls 2-21
CLOCK (if equipped)
To Next Page
Loading...