[ Edit: 2012/ 4/ 9 Model: E26-A ]
START (4)
GUID-DD003878-E53D-4A60-B580-E3DA670A425D
The engine starter activates and the engine will start.
The ignition switch, when released, will automatically
turn to the “ON” position.
CAUTION:
As soon as the engine has started, release the
ignition switch immediately.
GUID-308DB728-8727-4BA3-A36A-14969820D332
GASOLINE ENGINE
GUID-D72B9794-0773-46F9-AB26-5F5F4A00B14A
1. Apply the parking brake.
2. Depress the foot brake pedal.
3. Automatic Transmission (AT) model:
Move the selector lever to the “P” (Park) or “N”
(Neutral) position.
The starter is designed to operate only when
the selector lever is in the proper position.
Manual Transmission (MT) model:
Move the shift lever to the “N” (Neutral) position,
and depress the clutch pedal to the floor while
starting the engine.
4. Crank the engine with your foot off the accelerator
pedal by turning the ignition switch to the “START”
position.
5. Immediately release the ignition switch when the
engine starts. If the engine starts, but fails to run,
repeat the above procedures.
If the engine is very hard to start in extremely cold
or hot weather, depress the accelerator pedal and
hold it to help start the engine.
CAUTION:
. Do not operate the starter for more than 15
seconds at a time. If the engine does not
start, turn the ignition switch off and wait 10
seconds before cranking the engine again.
Otherwise, the starter could be damaged.
. If it becomes necessary to start the engine
with a booster battery and jumper cables,
the instructions and cautions contained in
the “6. In case of emergency” section should
be carefully followed.
6. Allow the engine to idle for at least 30 seconds
after starting the engine to warm-up. Drive at
moderate speeds for a short distance first,
especially in cold weather.
CAUTION:
Do not leave the vehicle unattended while the
engine is warming up.
DIESEL ENGINE
GUID-7AAF3A32-BDE 7-4A35-9C6C-D73A426671FE
1. Apply the parking brake.
2. Depress the foot brake pedal.
3. Automatic Transmission (AT) model:
Move the selector lever to the “P” (Park) or “N”
(Neutral) position.
The starter is designed to operate only when
the selector lever is in the proper position.
Manual Transmission (MT) model:
Move the shift lever to the “N” (Neutral) position,
and depress the clutch pedal to the floor while
starting the engine.
4. Turn the ignition switch to the “ON” position and
wait until the glow plug indicator light
turns
off.
5. Crank the engine with your foot off the accelerator
pedal by turning the ignition switch to the “START”
position.
6. Immediately release the ignition switch when the
engine starts. If the engine starts, but fails to run,
repeat the above procedures.
Starting and driving 5-7
STARTING ENGINE
To Next Page
Loading...