REMOTE KEYLESS ENTRY SYSTEM
(if so equipped)
LOCK DOORS
Press the LOCK button to lock all doors.
UNLOCK DOORS
Press the UNLOCK button once to unlock
the driver’s door only. Press the button again
within 5 seconds to unlock all doors.
USING THE PANIC ALARM
Press and hold the PANIC button for longer
than 0.5 seconds. The panic alarm will sound and the headlights will stay on
for 25 seconds. The panic alarm stops when it has run for 25 seconds, or
when any button is pressed on the keyfob.
SILENCING THE HORN BEEP FEATURE
To deactivate – Press and hold the LOCK and UNLOCK buttons for at least
2 seconds.
To activate – Press and hold the LOCK and UNLOCK buttons for at least
2 seconds once more.
10
CHILD SAFETY REAR DOOR LOCK
Child safety locks help prevent the rear doors from being
opened accidentally, especially when small children are
in the vehicle. The child safety lock levers are located on
the edge of the rear doors. When the lever is in the LOCK
position, the door can be opened only from the outside.
PRESET A·B·C BUTTON
Press the PRESET A·B·C button until you reach the desired setting. The radio is
equipped with three separate banks, each with six station presets. You may store
any combination of AM, FM or SAT* radio presets on each bank.
CLOCK BUTTON
To set the clock, press and hold the CLOCK button until it beeps. The hours will
start flashing. Press CAT FOLDER or SEEK/TRACK to adjust the hours. Press the
CLOCK button to switch to the minute adjustment. Press CAT FOLDER or SEEK/
TRACK to adjust the minutes.
SEEK/TRACK BUTTON
To scan quickly through each broadcasting station, press the SEEK/TRACK button.
To skip from one track to another on a CD, press the SEEK/TRACK button. Each
time the button is pressed, the CD will advance or skip back one track.
SCAN RPT BUTTON
Press the SCAN RPT button to stop at each broadcasting station (AM, FM or SAT
if so equipped) for 5 seconds. Pressing the button again during this 5-second
period will stop scan tuning and the radio will remain tuned to that station. If the
SCAN RPT button is not pressed within 5 seconds, scan tuning moves to the
next station.
CAT FOLDER BUTTON
To manually tune the radio, press the CAT FOLDER tune button (< or >) or turn the
tuning knob to the right or left. To move quickly through the channels, hold either the
< or > button down for more than 1.5 seconds.
LOAD BUTTON
To insert a CD, press the LOAD button for less than 1.5 seconds. Select the
loading slot by pressing the CD insert select button (1-6), then insert the CD.
To insert 6 CDs in the CD changer, press and hold the LOAD button for more
than 1.5 seconds. The slot numbers (1-6) will illuminate on the display when the
CDs are loaded in the changer.
STATION AND CD SELECT BUTTONS
To store a radio station in a preset you must first select A, B, or C memory bank
by pressing the PRESET A·B·C button and tuning to the desired AM, FM, or
SAT* station. Then, press and hold the desired station select button for at least
2 seconds. When the preset indicator illuminates, a beep will sound, indicating
memorization is complete. To retrieve a previously set station, select the memory
bank where the preset was set, then press the corresponding station select button.
AM/FM/SAT* RADIO WITH CD PLAYER (if so equipped)
FRONT SEAT ADJUSTMENTS
Pull up on the lever under the front of the
seat and slide backward or forward. Release
the lever to lock the seat in position.
Lift the lever on the side of the seat to adjust
your seatback backward or forward; release
when you have found a comfortable angle
and the seat belt fits properly.
01
SEAT LIFTER (if so equipped)
Turn either dial to adjust the angle and height of the seat cushion to the
desired position.
02
FOLDING THE SECOND ROW BENCH SEAT
To fold the 2nd row bench seat flat for maximum cargo hauling:
Lower the head restraints to the full “down” position. Pull the strap located in the
center of each seat cushion forward, and fold each seat cushion toward the front of
the vehicle.
01
Then pull the straps located on the outside edge of each seatback to fold the
seatbacks forward.
02
This easy-to-use Quick Reference Guide is intended to help you more fully appreciate
some of the unique features and functions of your new vehicle. However, it is not
intended to replace your Owner’s Manual. The Owner’s Manual contains more detailed
information to help you better understand the important safety warnings, features,
operation, and maintenance of your vehicle.
QR6E-0N50U1 Printing: April 2006 (04)
Nissan, the Nissan Brand Symbol, “SHIFT_” tagline, Z and Nissan model names are Nissan trademarks.
©2006 Nissan North America, Inc.
Shift_
TIRE PRESSURE MONITORING SYSTEM (TPMS)
This system monitors tire pressure. Please remember, this
system does not detect a sudden drop in tire pressure (for
example, a blowout while driving). It also does not monitor
the air pressure in the spare tire.
Tire pressure is affected by temperature. Low outside temperature causes lower tire
pressure. This may cause the low tire pressure warning light to illuminate.
If the low tire pressure warning light illuminates, check the tire pressure in all four tires.
Adjust the low tire pressure to the recommended COLD tire pressure shown on the Tire
and Loading Information label to turn the low tire pressure warning light off.
If TPMS is not functioning properly, the low tire pressure warning light will flash for
approximately 60 seconds when the key is turned on. After 60 seconds, the light will
remain on. Have the system checked by a NISSAN dealer.
* SAT presets are only available on SAT equipped vehicles.
02
01
04
05
07
03
06
05
04
07
06
03
02
01
HILL DESCENT CONTROL (HDC) SWITCH
(if so equipped)
The hill descent control system is designed to reduce driver workload
when going down steep hills. The HDC system helps to control vehicle
speed so the driver can concentrate on steering the vehicle.
To activate the HDC system:
The automatic transmission selector lever must be in forward or
reverse gear,
The 4WD switch must be in the 4L position and the vehicle speed must be under
15 MPH (25 km/h), or
The 4WD switch must be in the 4H position and the vehicle speed must be under
21 MPH (35 km/h), and
The HDC system switch must be ON.
The HDC indicator light will come on when the system is activated. Also, the stop/tail
lights illuminate while the HDC system applies the brakes to control vehicle speed.
To turn off the HDC system, push the switch to the off position. The HDC system is
temporarily disabled when the brake or accelerator pedal is depressed.
Refer to your Owner’s Manual for detailed information.
HILL START ASSIST (HSA) (if so equipped)
The hill start assist system automatically keeps the brakes applied to help prevent the
vehicle from rolling backwards in the time it takes the driver to release the brake pedal
and apply the accelerator when the vehicle is stopped on a hill.
HSA will operate automatically under the following conditions:
The selector lever is shifted to a forward or reverse gear.
The vehicle is stopped completely on a hill by applying the brake.
The maximum holding time is 2 seconds.
FOLD FLAT FRONT PASSENGER SEAT
(if so equipped)
To fold the front passenger’s seatback flat for extra
storage length when transporting long items:
Slide the seat to the rearmost position. Lift up on
the recline lever, located on the outside edge of
the seat, and fold the seatback forward as far as it
will go.
01
Lift up on the latch located on the upper corner of the seatback to release the back of
the seat.
02
Once the seatback is released, it will enable you to fold the front passenger seatback
flat over the seat cushion.
08
01
02
08
E-LOCK SWITCH (if so equipped)
The Electronic Locking Rear Differential (E-Lock) system can help
provide added traction if the vehicle is stuck or becoming stuck.
To activate the E-Lock system:
The 4WD switch must be in the 4LO position
(4-wheel drive vehicles),
The vehicle must be stopped or moving at 4 MPH (7 km/h) or
less, and
The E-Lock system switch must be turned on.
Once the vehicle is moving or under way, the system should be turned off.
CHANNEL TIE-DOWN HOOKS
The adjustable channel tie-down hook
system allows you to move the tie-down
hooks in the cargo area to the best location
to secure a load.
Refer to your Owner’s Manual for loading
limits and tie-down recommendations.
ADDITIONAL FEATURES (continued)
MP3 PLAyBACK
In addition to playing audio CDs, this radio can play MP3 files recorded on
CD-ROM, CD-R, and CD-RW discs. Each disc can have a maximum of 8 folder
levels and 255 folders. A total of up to 512 MP3 files can be played back. During
MP3 playback, any recorded ID3 tag information can be displayed by pressing the
DISP button. Use the CAT FOLDER button to navigate the MP3 files.
Shift_your limits
2006 XTERRA
QUICK REFERENCE GUIDE
01
SEAT BELT WARNING LIGHT AND CHIME
The light and chime remind you to fasten your seat
belts. The light illuminates whenever the ignition key
is turned to the ON or START position and remains
illuminated until the driver’s seat belt is fastened. At
the same time, the chime sounds for about 6 seconds
unless the driver’s seat belt is securely fastened.
The seat belt warning light may also illuminate if the front passenger’s seat belt is
not fastened when the front passenger’s seat is occupied (if so equipped). For 5
seconds after the ignition switch is in the ON position, the system does not activate
the warning light for the front passenger.
Refer to the Owner’s Manual for detailed information regarding seat belt usage.
ADDITIONAL FEATURES
01
02
01
02
To Next Page
Need help?
General
