To Next PageTo Next Page
Need help?Do you have a question about the Nitelighter NL50 and is the answer not in the manual?
To reduce risk of injury, do not permit children to install or operate this product.
DO NOT use an extension cord with this product - shock risk.
DO NOT operate the product from inside the pool or while hands are wet.
Power supply must be plugged into a 110/120 VAC GFCI protected outlet.
DO NOT use this product if it is damaged in anyway.
Ensure the power supply is off the ground and not resting in standing water.
DO NOT modify this product in any way - shock risk and will void warranty.
Ensure all plugs are secure prior to operating the product.
If ambient air temp exceeds 115°F, protect power supply from direct sunlight.
Never carry the power supply by the cord or pull the plug out of the outlet by the cord.
The light must be submerged at or below the minimum level requirement to extend life.
This light is not compatible with all pools including soft sided pools.
Align cord end with socket on power supply and secure threaded collar.
Connect the power supply to a GFCI protected outlet.
Press and release the button on the power supply; the light should illuminate.
Press and release the button on the power supply to turn the light off.
Unplug the power cord from the GFCI outlet after testing.
Confirm the wire from the light is connected to the power supply.
Ensure enough wire reaches the installation location without stress.
Remove the top cap of the pool's vertical post nearest to the installation point.
Lift one side of the pool's top ledge; screws may need removal.
Slide the light onto the pool wall, centering it on the top ledge.
Hold light flush with wall and turn Thumb Wheel clockwise to secure.
Ensure the wire runs through the Wire Channel of the Mounting Bracket.
Reinstall the top ledge and cap after mounting the light.
Ensure water level is above the minimum water line indicated by the first row of dots.
Mount the transformer to a vertical surface at least 18 inches from the ground.
Ensure the connection between the light cord and power supply is secure.
Ensure water level is above the minimum water line indicated by the first row of dots.
Plug the 3-pronged cord into a GFCI outlet.
Press and release the button on the power supply; the light will illuminate.
Light turns off automatically in 2 hours or manually via the power supply button.
Unplug the power supply from the outlet before winterizing.
Disconnect the cable from the light to the power supply.
Remove the light from the pool following installation steps in reverse.
Store the light and power supply in an area that will remain above 50°F.
Ensure the GFCI is working properly and reset the outlet if necessary.
Remove any extension cord and plug the power supply directly into a GFCI outlet.
Ensure the wire from the light to the power supply is connected properly.
Call Technical Support at 732-730-9880 to initiate a warranty claim.
General| Brand | Nitelighter |
|---|---|
| Model | NL50 |
| Category | Underwater lighting |
| Language | English |
