NITEO TOOLS MLTM0037-21 - Page 30

30
5. Failure to observe the recommendaons in this
manual may result in damage to or destrucon of
the mulmeter, and in hazard to the user’s health
and life.
6. Full compliance with safety standards may only be
guaranteed when the included probes are used. In
case of damage, the wires should be replaced with
wires that have the same electrical parameters.
7. Cauon! Do not use damaged
measuring wires. During
the measurement, you must not
touch the measuring ps and sockets. Do not
perform measurements when your hands are wet
or in places where the humidity level is high! Risk
of electric shock!
8. When measuring high voltage, wear insulang
gloves.
9. Cauon! If you do not know
the measured value, always use the
maximum value for the given
measurement to avoid damage to the device.
10. Prior to changing the range with the switch,
disconnect the measuring probes from the measured
circuit.
11. When the mulmeter is connected to the measured
circuit, do not touch the unused terminals.
12. Never use the mulmeter to measure voltages which
may exceed 300 V or 300 V~.
13. Always remember that high-amplitude pulses
with the potenal to damage the mulmeter may
occur at the test points.
14. If you work with AC voltages of more than 30 V