NITEO TOOLS MLTM0037-21 - Page 37

37
1. Unscrew the two screws (a cross-head screwdriver is
not included).
2. Remove the rear panel of the mulmeter.
3. Remove the spent baery, if present. Insert a new
baery, observing the polarity markings (shown in
the picture below).
4. Aer connecng the baery, insert the baery into
the baery compartment (8), minding the wires.
5. Reinstall the rear panel. Tighten the screws.
When the baery in the mulmeter is exhausted and
requires replacement, the following icon will be shown
on the display: .
Aenon! The baeries may be protected with a piece
of insulaon lm, which must be removed before using
the device for the rst me.
• Use the type of baeries recommended for this
device.