To Next PageTo Next Page
Need help?Do you have a question about the Nitto ATRA ACE A-100 and is the answer not in the manual?
Essential safety guidelines for operating power tools to prevent accidents and injuries.
Guidelines for operators regarding clothing, footwear, hair, and posture to ensure safe operation.
Mandatory use of safety glasses that comply with ANSI standards for eye protection from flying chips.
Requirement to wear hearing protection due to loud operational noise to prevent hearing loss.
Avoid touching the moving or cutting tip to prevent severe injuries from contact.
Ensuring a clean, dry, and well-lit work area, avoiding flammable materials and children.
Verify all parts are free from damage, secure the workpiece and machine, and remove tools.
Never leave the machine unattended while running; disconnect power before leaving the work area.
Do not disassemble or modify the machine; service must be done by authorized dealers to prevent accidents.
Inspect the machine, pilot pin, and cutter for damage or wear before each use.
Ensure proper grounding to prevent electric shock; consult an electrician if unsure.
Do not abuse, damage, or carry the machine by the power cord to prevent electrocution or fire.
Use a ground fault circuit interrupter as required by regulations to prevent electric shock.
Avoid abrupt or unintentional starting; ensure the switch is off before connecting power.
Operating on ceilings or sides is dangerous; machine could fall, causing severe injury or death.
Do not use the Magnet for more than five hours continuously to prevent overheating and fire.
Do not use the Drill Motor for over 30 minutes continuously to prevent overheating and fire.
Use only on magnetic materials; the magnet will not work on non-magnetic materials, risking accidents.
Use caution during wall operation; never stand under the machine or put body parts under it.
Comprehensive guide covering punching, surface preparation, alignment, and drilling operations.
Turn the Feed Handle counterclockwise slowly for the first 2-3mm depth cutting.
Always disconnect power before any maintenance to prevent accidents and severe injuries.
Diagram is for reference only; do not attempt self-service or repair; contact an authorized dealer for all service needs.
General