185 to 200 128, 32, 16, 8
193 to 208 128, 64
201 to 216 128, 64, 8
209 to 224 128, 64, 16
217 to 232 128, 64, 16, 8
225 to 240 128, 64, 32
233 to 248 128, 64, 32, 8
241 to 256 128, 64, 32, 16
Do not set all switches ON
The DMX address for each half of te IF32 can be set
independently.
The 0 to 10 Volt analogue control signals corresponding to
the DMX channels selected appear on the 7-pin DIN sockets.
The lowest numbered DMX address appears on IF32 output
channel 1, and the highest on IF32 output channel 16.
For example: If switches are set with Switch 128 and 8 on
and others off. This selects DMX addresses 137 to 152. DMX
address 137 will control channel 1, 138 will control channel 2,
139 will control channel 3, and so on, up to DMX address 152
which will control channel 16 on the IF32.
The IF32 cannot be used with DMX addresses above 256.
Cont rolling power packs from an
intelligent DMX cont roller such as Merlin.
For a dimming power pack
Output brightness is proportional to DMX data:
DMX data = 255 output fully on
DMX data = 128 output at half brightness
DMX data = 64 output at quarter brightness
DMX data = 0 output fully off (if preheat is disabled)
These are only examples, the IF32 and a dimming power
pack can produce all 256 levels of brightness from fully off to fully
on.
© N.J.D. Electronics 1997 -Page 6-
IF32 User Guide
To Next Page
Loading...