MOUNTING GRID AND PROPELLER
1. Place the rear part of the fan grille over the motor shaft (1). Make sure the locking bolt and nut are at the bottom (2), then secure
the rear fan grille with the plastic fixing nut (3).
2. Place the propeller on the motor shaft up to the spindle pin and secure the propeller with the propeller nut (4).
3. Place the front side of the fan grille on the rear side and check that both grilles are flush before fastening both with the 4 clamps (5).
4. Secure the fan grille by tightening the locking bolt and nut (6)
INSTRUCTIONS FOR USE
Check that the fan is placed on a solid and level surface.
THE FAN HAS THE FOLLOWING CONTROLS
0 = Off
1 = Quiet soft breeze
2 = Normal speed
3 = Maximum speed
The automatic swivel can be switched on by pulling the swivel button upwards. Press the swivel button down again to deactivate the swing.
The direction of blow can be set by loosening the tilting pad (7).
To Next Page
Loading...