To Next PageTo Next Page
Need help?Do you have a question about the NK-Optik Otoflash G171 and is the answer not in the manual?
Overview of front panel components and controls for the device.
Overview of rear panel connections and indicators for the device.
How to set the number of flashes for the curing process.
How to start the curing process and its behavior.
Indicators for defective lamps during operation.
Instructions for cleaning and replacing the air filter.
Guidelines for cleaning external surfaces and components.
Information on professional servicing by the manufacturer.
Conditions for transporting and storing the device.
Guidelines for storing the device in closed rooms.
Procedures for disposing of device components as waste.
Protective gas function with pre-flooding enabled.
Protective gas function is switched off.
Protective gas active without pre-flooding.
Important notes and considerations for protective gas usage.
General| Category | Lighting Equipment |
|---|---|
| Light Source | Xenon Flash Lamps |
| Number of Flash Lamps | 2 |
| Gas | Xenon |
| Power Supply | 230 V, 50/60 Hz |
