nodon PIR-2-1-0 series User Manual

The NodOn
®
PIR Motion Sensor allows to detect motion and trigger actions directly on
your actuators (such as NodOn
®
Smart Plug, NodOn
®
In-Wall module, etc…) or through your
EnOcean
®
compatible Home Automation gateway. Use your NodOn
®
PIR Motion Sensor in
standalone mode with a NodOn
®
actuator to perform simple and construction work-free
Smart Lighting Management, or integrate it into your EnOcean
®
Smart Home ecosystem.
INSTALLATION
Thanks to its shape and the included accessories, you can install your PIR Motion Sensor
anywhere in your house.
On your desk On your wall On your ceiling
ON YOUR WALL
a Use a screw to hang your sensor on the wall.
b Stick your sensor on the wall with the double sided tape.
c Screw the support on the wall to mount your sensor on it.
ON YOUR CEILING
d Drill a 45mm diameter hole in thin ceiling to insert the included fastening hooks and
mount the support in them.
e Mount your sensor into the support.
PIR Motion Senror by NodOn
®
Reference: PIR-2-1-0x
Power supply: battery CR123A 3V
Lifetime: 5 years
Center radio frequency : 868.3 MHz
Occupied frequency band : 868.0 to 868.6 MHz
RF power Max : +3dBm
Wireless range: Up to 30 meters
Detection range: Up to 5 meters
Lux sensing: 0 to 1000Lux
Operational temperature: -10°C / 45°C
EEP (Prol EnOcean
®
): A5-07-03
Dimensions: 65 mm (l) x 65 mm (L) x 39 mm (h)
Weight: 54 g
Warranty: 2 years
USER GUIDE
PIR - MOTION SENSOR

nodon PIR-2-1-0 series Specifications

General

Power Supply	Battery
Battery Type	CR123A
Battery Life	Up to 5 years
Radio Protocol	EnOcean
EnOcean Equipment Profile (EEP)	A5-07-01
Product Type	Motion Sensor
Operating Frequency	868.3 MHz
Detection Range	8 meters
Detection Angle	90 degrees
Operating Humidity	85% RH max
Weight	90 g
Certification	CE

Summary

Installation Methods

Desk Installation

Illustrates placing the motion sensor on a desk surface for immediate use.

Wall Mounting Options

Covers methods for attaching the sensor to a wall using screws or adhesive tape.

Ceiling Mounting

Details the process of installing the sensor on a ceiling using included fastening hooks.

Operation and Settings

Replacing the Battery

Instructions for opening the product and replacing the battery, advising care for the sensing part.

Pairing Procedures

Steps for connecting the sensor to receivers or gateways in standalone or gateway modes.

Walk Test Mode

Explains the sensor's initial 3-minute mode for testing placement and efficiency.

Auto Off-Time Configuration

Configures the delay before the sensor switches off receiver when no motion is detected.

Low Battery Notification

Describes the LED signal indicating when the battery needs replacement.

Heartbeat Functionality

Details the automatic frame sent every 30 minutes containing sensor status and battery level.

Ambient Light Sensitivity

Adjusts ambient light threshold for motion detection, with a potentiometer control.

Contact and Support

Manufacturer Details

Provides the name and address of the manufacturer and importer.

After Sales Support

Lists website and email for user guides and support inquiries.