1.1 SAFETY
4
The power supply must be protected by a residual current device of at least 30 mA,
especially when installed in a room with a bath or shower.
If the power supply cable is damaged, it must be replaced by the manufacturer, its
after-sales service or a person with similar qualifications in order to prevent any
potential hazards.
The heater risks overheating if it is
covered. The following logo reminds
users of this risk.
It is therefore strictly forbidden to cover or block the air intakes or outlets at the risk
of causing an accident or damaging the heater.
Comply with the minimum installation distances from floors, walls, furniture, etc.
When installing the heater in bathrooms, it must comply with local regulations.
Avoid installing the heater in a draught which may otherwise affect its thermostat
control.
This direct electric heater is designed for ambient heating of residential type rooms,
or similar, in new or existing, single and multi-unit dwellings.
Do not use this heater in the immediate surroundings of a bath, a shower or a
swimming pool.
Do not use this heater if it has been dropped.
Do not use if there are visible signs of damage to the heater.
Use this heater on a horizontal and stable surface on castors, or fix it to the wall, as
applicable.
Do not use this heater in small rooms when they are occupied by persons not
capable of leaving the room on their own, unless constant supervision is provided.
To reduce the risk of fire, keep textiles, curtains, or any other flammable material to
a minimum distance of 1m from the air outlet.
(*) These instructions were correct at the time of the heater's manufacture and
comply with the standards applicable as at that date. The company reserves the
right to modify the Installation and User Guide at any time in order to take into
account any new standards or changes to existing standards.
To Next Page
Loading...
