2.3 INSTALLATION
ELECTRICAL CONNECTION
This heater is fitted with an Australian Approved Flexible Cord and Plug. For wall-
mounted installations connection can be either by plugging into an existing
10amp power point (DIY) or direct wired by a Licensed Registered Electrical
Contractor, who is required to issue a Certificate of Electrical Safety.
PLEASE NOTE:
For safety reasons the Flexible Cord must not be modified or repaired in any way.
If there are any concerns, contact Olimpia Splendid Pty Ltd on 1 300 664 768
before plugging in.
IMPORTANT:
DO NOT PLUG HEATER INTO A POWER BOARD,
DOUBLE ADAPTOR OR EXTENSION LEAD.
USING YOUR HEATER FOR THE FIRST TIME
Remove the heater from its packaging (please dispose of packaging responsibly).
Contents should be as follows:
1.Heater
2.Wall bracket (pre-attached to the back of the heater)
3.Instructions for installation and use (booklet)
4.Castors (Note: not included with Evolution models)
Ensure the heater is correctly mounted on the wall or fitted to the castors prior to
turning it on. Remove the white plastic protective covers from the plug pins and
insert the plug into the wall socket.
NOTE: When first turning on your new heater, we recommend doing so in a
large, open space or ventilated room for a few minutes to allow the “new heater
smell” to dissipate. It is also common for the heater to emit vapour from the vents
during this initial process and shouldn’t last for more than 2-3 minutes. If it should
persist, switch the heater off and have it inspected.
Noirot is distributed by Olimpia Splendid. For additional Support, please go to:
www.olimpiasplendid.com.au
8
WARNING
Do not connect to power board
To Next Page
Loading...
