Messages
32
Save voice mail dialing code
You can insert special characters called dialing codes into phone numbers such
as voice mail, and save the number to a 1-touch dialing location. Dialing codes
instruct the receiving system to pause, wait, bypass, or accept the numbers that
follow them in the dialing string.
Voice mail is a network service. The following instructions are examples of
common operations. Please check with your service provider for specific
instructions for using your voice mail service.
Write down number and process
1. Write down your voice mailbox number.
2. Call and check your voice mail as you normally would.
3. Write down your interaction with the recorded prompts step-by-step. Note
that each voice mail service may vary. Your steps may resemble the following:
Dial 2145551212, pause 5 seconds, press 1, pause 2 seconds, press 1234, and
press *.
Be precise; you will need this information in "Set up voice mail with dialing
codes," page 32.
Insert dialing codes
Press * repeatedly to cycle through dialing codes. When the desired code appears
in the display, pause briefly and the code is inserted into the dialing string.
The following dialing codes are available:
Set up voice mail with dialing codes
1. Select Contacts > 1-touch dialing.
2. Scroll to an empty 1-touch dialing slot, and select Assign.
3. Enter your voice mailbox number, including the area code.
Dialing code Indicates...
* Bypasses a set of instructions.
+ Causes the international access code to be replaced by +.
p Pauses for 2.5 seconds before sending any numbers that follow.
w Waits for you to press the call key before sending the numbers
or codes that follow.
N1315_UG_EN_Non-RUIM_Vivo_FCC_0804.fm Page 32 Friday, August 4, 2006 6:02 PM
To Next Page
Loading...
