Getting Started
8
Mounting the GSM terminal
Mount the GSM terminal on the
application module using the three
screws supplied with the terminal.
Connecting the power
supply
1 Connect the power cord from the
power supply to the terminal.
2 Connect the power supply to an
AC wall outlet.
Connecting a telephone
Connect a DTMF telephone to the trunk connector.
Warning! To avoid damage to the devices, the telephone must
be connected to the trunk connector with a standard 4-pin RJ-
11 cable that has only its two middle pins connected.
Entering the PIN code
The PIN (Personal Identification Number) code protects your SIM card
against unauthorised use. It is usually supplied with the SIM card. Use
the telephone connected to the terminal to enter the PIN code.
When light indicator 4 blinks, lift the receiver. When the enter PIN code
tone is heard, enter the PIN code followed by #. The OK tone is heard and
light indicator 3 lights up. If the opeartion fails, see Entering PIN Code
Does Not Succeed on page 16.
53068en_1.fm Page 8 Tuesday, March 20, 2001 2:30 PM
To Next Page
Loading...
