Nokia 3210 - For your safety; ROAD SAFETY COMES FIRST; SWITCH OFF IN HOSPITALS; SWITCH OFF IN AIRCRAFT

CONFIDENTIAL 8 (48)
NSE-8/9 Repairhints
Customer Care Europe & Africa Version 5.0 Approved
Technical Services Training Group Date: 05.09.2001
© 2001 Nokia Mobile Phones
Checked by:
CC Training Group
Approved by:
Technical Services
CHARGING PROBLEMS
Check if R103 is broken – if resistor was broken or missing: Change N101, too.
Check C-Cover version, cut the arrow of the time dial in cover or change C-Cover if necessary.
(Service Bulletin 024).
NOT CHARGING (with ACP-7 charger only)
If battery is totally discharged – R132 must be changed to 150k / 1% tolerance and R131 must be changed to
82k / 1% tolerance resistor.
For detailed information see Service Bulletin 042.
POOR OR NO SERVICE
13MHz oscillator (G701) must be changed from version “A“ (NGK3092A) to new version “B“ (NGK3092B).
This version “A” VCTCXO is a component used for phones labeled “Made in Finland”, but only within the
IMEI range below mentioned.
First NSE-8 IMEI 448896/10/274359/9
Last NSE-8 IMEI 448896/10/422812/8
First NSE-9 IMEI 448898/10/098643/6
Last NSE-9 IMEI 448898/10/149081/8 (Service Bulletin 018)
TIME & RINGTONE PROBLEMS
In some cases the ringtone and/or the clock work too slow or too fast – in these cases C148 must be changed to 47p, J 50V and
C153 to 18p, J 50V and check 32.768kHz sine- & squarewave signals of B100.
Change oscillator if necessary (Service Bulletin 017).