32Copyright © 2006 Nokia. All rights reserved.
Enhanced voice dialing
To make a phone call, select and hold Names, and say the name of the contact you wish to call. The phone will
automatically associate a virtual voice tag with each contact in the phone memory.
Make a voice dialing call
If an application is sending or receiving data using a packet data connection, end the application before you
use voice dialing in GSM. In WCDMA it is possible to send voice and data simultaneously.
Voice commands are language-dependent. To set the language, see Voice playback language in “Phone,” p. 71.
Note: Using voice tags may be difficult in a noisy environment or during an emergency, so you should not rely
solely upon voice dialing in all circumstances.
1. In the standby mode, press and hold the right selection key. A short tone is played, and Speak now is
displayed.
If you are using a compatible headset with the headset key, press and hold the headset key to start the voice
dialing.
2. Say the voice command clearly. If the voice recognition is successful, a list with matches is shown. The
phone plays the voice command of the match on the top of the list. After about 1.5 seconds, the phone dials
the number; or if the result is not the correct one, scroll to another entry, and select to dial the entry.
Using voice commands to carry out a selected phone function is similar to voice dialing. See Voice
commands in “My shortcuts,” p. 62.
■ Answer or reject a voice call
To answer a call, press the call key.
To mute the ringing tone before you answer the call, select Silence.
To end the call or reject a call, press the end key.
To Next Page
Loading...
