nokia
CONNECTING PEOPLE
PAGE 17 (26) Approved 1.0
CMO Operations & Logistics
DJK
WW Service Solutions & Development
Bochum / Germany CONFIDENTIAL 22.02.2005
40.) Push out the Slide Sensor with tweezers.
41.) Now, remove the Slide Sensor. Note the right
position when re-assembling.
10. REMOVAL OF SHIELDING LIDS
1.) Use always the Soldering Jig as a support when
working on the Engine Module.
2.) Open the clips of the Shielding Lids with the dental
tool.
3.) The lid can be removed, if all clips of the Shielding
Lid are in the shown position.
4.) Use a slotted screwdriver as a lever to lift the
Shielding Lids. Always use new Shielding Lids for re-
assembly.
Service Manual 6680 Level 1&2 Copyright © 2005 Nokia Corporation. All rights reserved.
To Next Page
Loading...
