Nokia 6800 - Connecting to a WAP Service

Copyright2003 Nokia. All rights reserved.
138
Connecting to a WAP service
Firstly, make sure that the service settings of the WAP service that you want to
use have been activated. To activate the settings:
• Press Menu and select Services, Settings and Connection settings. Select
Active service settings and scroll to the set you want to activate and press
Activate.
Secondly, make a connection to the WAP service. There are three ways to connect:
• Open the homepage of the WAP service:
Press Menu and select Services and Home.
Tip: To quickly open the homepage of a WAP service when the flip is
closed, press and hold in standby mode. When the flip is open,
press the corresponding number key.
Or:
• Select a bookmark of the WAP service:
Press Menu and select Services, Bookmarks, and select a bookmark.
If the bookmark does not work with the current active service settings, activate
another set of service settings and try again.
Or:
• Key in the address of the WAP service:
Press Menu and select Services and then Go to address. Key in the address of
the WAP service, press for special characters (or if the flip is open),
and press OK.