Nokia 710 - Page 20

Nokia 701 (RM-774)
L1L2 Service Manual
20
Co nf id e nt ial | Co p yright © 2011 Nokia | A ll rights reserved
V e rs io n 4 .0
7) Tighten these three TORX + size 6 screws to the
torque of 13Ncm in the order shown.
8) When assembling the DISPLAY, feed the DISPLAY
flex under the A-COVER SENSOR SUPPORT PAD. Be
careful not to damage the flex.
9) Turn the A-COVER over the B-COVER so that the
edge of the top side is slightly over the B-COVER.
10) First push the top side of the A-COVER to
direction shown and then press down from both
sides.
11) Tighten these two TORX + size 6 screws to the
torque of 13Ncm in the order shown.
12) Tighten these two TORX + size 4 screws to the
torque of 18Ncm in the order shown.