Nokia 7210 SAS-M Configuration Guide

Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 137
Service Management Tasks
This section discusses basic procedures of the following service management tasks:
• Modifying a Card Type on page 138
• Deleting a Card on page 139
• Deleting Port Parameters on page 139
To change an MDA type already provisioned for a specific slot/card, first you must shut down the
slot/MDA/port configuration and then delete the MDA from the configuration. Modify and delete
operations can be performed only on the MDAs that are not auto equipped or auto
provisioned.Use the following CLI syntax to modify an MDA:
CLI Syntax: config> port port-id
shutdown
CLI Syntax: config> card slot-number
shutdown
[no] mda mda-number
[no] mda-type mda-type
shutdown

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English