Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 171
egress-scheduler-policy
Syntax egress-scheduler-policy port-scheduler-policy-name
no egress-scheduler-policy
Context config>port>ethernet
Description Platforms Supported: 7210 SAS-M, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE, 7210 SAS-Sx 10/100GE,
and 7210 SAS-T.
This command enables the provisioning of an existing port-scheduler-policy to a port or channel.
The default scheduling done for a port is strict scheduling. When a port-scheduler-policy is applied to the
port, the scheduling behavior changes to the one specified in the policy (Strict, RR, WRR, WDRR, WRR/
WDRR + Strict).
The no form of the command removes the policy from the port and makes the scheduling scheme of the port
to strict.
The no form of this command removes a port scheduler policy from an egress port or channel. Once the
scheduler policy is removed, all orphaned queues and schedulers revert to a free running state governed only
by the local queue or scheduler parameters. This includes any queues or schedulers with a port-parent
association.
Parameters port-scheduler-policy-name — Specifies an existing port-scheduler-policy configured in the config>qos
context.
mode
Syntax mode {access [uplink]| network | hybrid}
no mode
Context config>port>ethernet
config>lag
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-12, 7210
SAS-Sx/S 1/10GE, 7210 SAS-Sx 10/100GE, and 7210 SAS-T.
Access: An access port is used for customer facing traffic on which services are configured. A Service
Access Point (SAP) can only be configured on an access port. When a port is configured for access mode,
the appropriate encap-type must be specified to distinguish the services on the port. Once an Ethernet port
has been configured for access mode, multiple services can be configured on the Ethernet port.
Access-uplink: Access-uplink ports are used to provide native Ethernet connectivity in service provider
transport or infrastructure network. This can be achieved by configuring port mode as access uplink. With
this option, the encap-type can be configured to only qinq. Access-uplink SAPs, which are QinQ SAPs, can
only be configured on an access uplink port to allow the operator to differentiate multiple services being
carried over a single access uplink port. It is supported only on 7210 SAS-M and 7210 SAS-T configured in
access-uplink mode.
Network: A network port participates in the service provider transport or infrastructure network when a
network mode is selected. When the network option is configured, the encap-type can be configured to
either null or dot1q.
To Next Page
Loading...
Need help?
General
