General Port Commands
Page 172 7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide
Hybrid: A hybrid Ethernet port allows the combination of network and access modes of operation on a per-
VLAN basis and must be configured as either dot1q or QinQ encapsulation. When the hybrid port is
configured to the dot1q encapsulation, the user configures a SAP inside a service by providing the SAP ID
which must include the port-id value of the hybrid mode port and an unused VLAN tag value. The format is
<port-id>:qtag1. A SAP of format <port-id>:* is also supported. The user configures a network IP interface
under config>router>interface>port by providing the port name which consists of the port-id of the hybrid
mode port and an unused VLAN tag value. The format
is <portid>:qtag1.
The user must explicitly enter a valid value for qtag1. The <port-id>:* value is not supported on a network
IP interface. The 4096 VLAN tag space on the port is shared among VLAN SAPs and VLAN network IP
interfaces. When the hybrid port is configured to QinQ encapsulation, the user configures a SAP inside a
service simply by providing the SAP ID which must include the port-id value of the hybrid mode port and
the outer and inner VLAN tag values.
The format is <port-id>:qtag1.qtag2. A SAP of format <port-id>: qtag1.* is also supported. The outer
VLAN tag value must not have been used to create an IP network interface on this port. In addition, the
qtag1.qtag2 value combination must not have been used by another SAP on this port. The user configures a
network IP interface under config>router>interface>port by providing the port name which consists of the
port-id of the hybrid mode port and a VLAN tag value. The format is <portid>:qtag1.*. An outer VLAN tag
qtag2 of * is used to create an IP network interface. In addition, the qtag1.qtag2 value combination must not
have been used on another SAP or IP network interface on this port.
The no form of this command restores the default.
Default network
Parameters network — Configures the Ethernet port as service access (available only in network mode).
access — Configures the Ethernet port for transport network use.
access uplink — Configures the Ethernet port for transport (ethernet uplinks available only in access-uplink
mode).
hybrid — Configures the Ethernet port for hybrid use (available only in network mode).
monitor-oper-group
Syntax monitor-oper-group name
no monitor-oper-group
Context config>port>ethernet
Description Platforms Supported: 7210 SAS-M/T access-uplink mode. It is not supported in 7210 SAS-M and 7210
SAS-T network mode, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE, 7210 SAS-Sx 10/100GE, 7210 SAS-X,
7210 SAS-R6 and 7210 SAS-R12.
This command specifies the operational group to be monitored by the object under which it is configured.
The oper-group name must be already configured under the config>system context before its name is
referenced in this command.
The no form of the command removes the association from the configuration.
Default no monitor-oper-group
To Next Page
Loading...
Need help?
General
