Ethernet Port Commands
Page 188 7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide
This command enables LACP packet tunneling for the Ethernet port. When tunneling is enabled, the port
will not process any LACP packets but will tunnel them instead. The port cannot be added as a member to a
LAG group.
The no form of the command disables LACP packet tunneling for the Ethernet port.
Default no lacp-tunnel
poe
Syntax poe [plus]
no poe
Context config>port>ethernet
Description Platforms Supported: 7210 SAS-T ETR, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE, and 7210 SAS-Sx 10/
100GEvariants.
This command enables POE on this port and allows only 802.3af (Type 1) low-power devices to be
connected to the port.
Using plus parameter, enabled users to connect Type 2 devices (that is, high-powered devices) compliant to
802.3at standards to the port.
This command must be used to enable PoE on a port before connecting a PoE device to the port. Once a port
is enabled for PoE, software attempts to detect the type of PoE device (that is, PoE or PoE+ device)
connected to the port and the power it is requesting when a PoE device is connected to the port. If the
detection is successful and the power request is within the budget that the platform supports, then power is
supplied to the connected device. If not, power is not supplied to the port.
The no form of the command disables PoE and PoE+ on this port. If PoE is disabled, the software does not
attempt to detect the characteristics of the PoE device connected to the port and not supply power to the port.
Parameters [plus] — The user can specify the parameter poe-plus to allow support of 802.3at (Type-2) high power
devices to be connected to the port.
oper-group
Syntax no oper-group
oper-group name
Context config>port>ethernet
config>lag
Description Platforms Supported: 7210 SAS-M/T access-uplink mode. It is not supported on 7210 SAS-M and 7210
SAS-T network mode, 7210 SAS-Sx/S 1/10GE, 7210 SAS-Sx 10/100GE, 7210 SAS-Mxp, 7210 SAS-X,
7210 SAS-R6 and 7210 SAS-R12.
To Next Page
Loading...
Need help?
General
