Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 191
The no form of the command allows the node to automatically determine the master or slave status for the
copper port based on the nodes capabilities exchanged during auto-negotiation. In other words, depending
on the peer setting, the local end could end up as either a master or a slave when the no form of the command
is used.
Note:
The following conditions must be met before using syncE on the fixed port copper ports:
1. Auto-negotiation (or auto-negotiation limited) must be turned on.
2. This command is required only when the copper port speed is set to 1Gbps.
3. This CLI command is not supported for fiber ports or for fiber ports that use Copper SFPs.
Parameters master — This option ensures that the local node is the synchronous Ethernet master. A synchronous
Ethernet master port, distributes the system timing over the copper port to the remote peer node.
slave — This option ensures that the local node is a synchronous Ethernet slave. A synchronous Ethernet
slave port uses the incoming timing information.
speed
Syntax speed {10 | 100 | 1000 | 10000}
Context config>port>ethernet
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command configures the port speed of a Fast Ethernet port when autonegotiation is disabled. If the port
is configured to autonegotiate this parameter is ignored.
Speed cannot be configured for ports that are part of a Link Aggregation Group (LAG).
The speed value supported for a platform depends on the speed of the ethernet interface supported on that
platform.
Default Varies for different platform according to speed value.
Parameters 10 — Sets the link to 10 mbps speed.
100 — Sets the link to 100 mbps speed.
1000 — Sets the link to 1000 mbps speed.
10000 — Sets the link to 10000 mbps speed.
loopback
Syntax [no] loopback {internal} [service svc-id sap sap-id src-mac SA dst-mac DA]
Context config>port>ethernet
To Next Page
Loading...
Need help?
General
