Nokia 7210 SAS-M Configuration Guide

Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 199
radius-plcy
Syntax radius-plcy name
no radius-plcy
Context config>port>ethernet>dot1x
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command configures the RADIUS policy to be used for 802.1x authentication. An 802.1x RADIUS
policy must be configured (under config>security>dot1x) before it can be associated to a port. If the
RADIUS policy-id does not exist, an error is returned. Only one 802.1x RADIUS policy can be associated
with a port at a time.
The no form of this command removes the RADIUS policy association.
Default no radius-plcy
Parameters name — Specifies an existing 802.1x RADIUS policy name.
re-auth-period
Syntax re-auth-period seconds
no re-auth-period
Context config>port>ethernet>dot1x
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command configures the period after which re-authentication is performed. This value is only relevant
if re-authentication is enabled.
The no form of this command returns the value to the default.
Default 3600
Parameters seconds — The re-authentication delay period in seconds.
Values 1 — 9000
re-authentication
Syntax [no] re-authentication
Context config>port>ethernet>dot1x
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command enables / disables periodic 802.1x re-authentication.

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English