Nokia 7210 SAS-M Configuration Guide

802.1x Port Commands
Page 200 7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide
When re-authentication is enabled, the 7210 SAS will re-authenticate clients on the port every re-auth-
period seconds.
The no form of the command returns the value to the default.
Default re-authentication
server-timeout
Syntax server-timeout seconds
no server-timeout
Context config>port>ethernet>dot1x
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command configures the period during which the 7210 SAS waits for the RADIUS server to responds
to its access request message. When this timer expires, the 7210 SAS will re-send the access request
message, up to the specified number times.
The no form of this command returns the value to the default.
Default 30
Parameters seconds — The server timeout period in seconds.
Values 1 — 300
supplicant-timeout
Syntax supplicant-timeout seconds
no supplicant-timeout
Context config>port>ethernet>dot1x
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command configures the period during which the 7210 SAS waits for a client to respond to its EAPOL
messages. When the supplicant-timeout expires, the 802.1x authentication session is considered to have
failed.
The no form of this command returns the value to the default.
Default 30
Parameters seconds — The server timeout period in seconds.
Values 1 — 300

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English