LLDP Ethernet Port Commands
Page 204 7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide
NOTE: Transparent forwarding of LLDP frames can be achieved using the standard defined mechanism
when using the either nearest-non-tmpr or the nearest-customer as the destination MAC address in the LLDP
frames. It is recommended that the customers use these MAC address where possible to conform to
standards. This command allows legacy LLDP implementations that do not support these additional
destinations MAC addresses to tunnel LLDP frames that use the nearest-bridge destination MAC address.
The no form of the command disable LLDP tunneling for frames using nearest-bridge destination MAC
address.
Default no tunnel-nearest-bridge-dest-mac
dest-mac
Syntax dest-mac {bridge-mac}
Context config>port>ethernet>lldp
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command configures destination MAC address parameters.
Parameters bridge-mac — Specifies destination bridge MAC type to use by LLDP.
Values nearest-bridge — Specifies to use the nearest bridge.
nearest-non-tpmr — Specifies to use the nearest non-Two-Port MAC Relay (TPMR) .
nearest-customer — Specifies to use the nearest customer.
admin-status
Syntax admin-status {rx | tx | tx-rx | disabled}
Context config>port>ethernet>lldp>dstmac
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command specifies the desired administrative status of the local LLDP agent.
Parameters rx — Specifies the LLDP agent will receive, but will not transmit LLDP frames on this port.
tx — Specifies that the LLDP agent will transmit LLDP frames on this port and will not store any
information about the remote systems connected.
tx-rx — Specifies that the LLDP agent transmitw and receives LLDP frames on this port.
disabled — Specifies that the LLDP agent does not transmit or receive LLDP frames on this port. If there is
remote systems information which is received on this port and stored in other tables, before the port's
admin status becomes disabled, then the information will naturally age out.
To Next Page
Loading...
Need help?
General
