LAG Commands
Page 220 7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide
This command configures the encapsulation method used to distinguish customer traffic on a LAG. The
encapsulation type is configurable on a LAG port. The LAG port and the port member encapsulation types
must match when adding a port member.
If the encapsulation type of the LAG port is changed, the encapsulation type on all the port members will
also change. The encapsulation type can be changed on the LAG port only if there is no interface associated
with it. If the MTU is set to a non default value, it will be reset to the default value when the encap type is
changed.
The no form of this command restores the default.
Default null — All traffic on the port belongs to a single service or VLAN.
Parameters dot1q — Ingress frames carry 802.1Q tags where each tag signifies a different service.
null — Ingress frames will not use any tags to delineate a service. As a result, only one service can be
configured on a port with a null encapsulation type.
qinq — This encapsulation type is specified for QinQ access SAPs.
hold-time
Syntax hold-time down hold-down-time
no hold-time
Context config>lag
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command specifies the timer, in tenths of seconds, which controls the delay between detecting that a
LAG is down (all active ports are down) and reporting it to the higher levels.
A non-zero value can be configured, for example, when active/standby signalling is used in a 1:1 fashion to
avoid informing higher levels during the small time interval between detecting that the LAG is down and the
time needed to activate the standby link.
Default 0
Parameters down hold-down-time — Specifies the hold-time for event reporting
Values 0 — 2000
lacp
Syntax lacp [mode] [administrative-key admin-key][system-id system-id] [system-priority priority]
Context config>lag
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
To Next Page
Loading...
Need help?
General
