Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 221
This command specifies the LACP mode for aggregated Ethernet interfaces only. This command enables the
LACP protocol. Per the IEEE 802.3ax standard (formerly 802.3ad), the Link Aggregation Control Protocol
(LACP) provides a standardized means for exchanging information between Partner Systems on a link to
allow their Link Aggregation Control instances to reach agreement on the identity of the Link Aggregation
Group to which the link belongs, move the link to that Link Aggregation Group, and enable its transmission
and reception functions in an orderly manner. LACP can be enabled on a maximum of 12 ports.
Default no lacp
Parameters mode — Specifies the mode in which LACP will operate.
passive — Starts transmitting LACP packets only after receiving packets.
active — Initiates the transmission of LACP packets. administrative-key admin-key — Specifies an
administrative key value to identify the channel group on each port configured to use LACP. This value
should be configured only in exceptional cases. If it is not specified, a random key is assigned.
Values 1 — 65535
system-id system-id — Specifies a 6 byte value expressed in the same notation as MAC address
Values xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx
system-priority priority — Specifies the system priority to be used for the LAG in the context of the MC-
LAG.
Values 0 — 65535
lacp-xmit-interval
Syntax [no] lacp-xmit-interval {slow | fast}
Context config>lag
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command sepcifies the interval signaled to the peer and tells the peer at which rate it should transmit.
Default fast
Parameters slow — Transmits packets every 30 seconds.
fast — Transmits packets every second.
lacp-xmit-stdby
Syntax [no] lacp-xmit-stdby
Context config>lag
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
To Next Page
Loading...
Need help?
General
