Nokia 7210 SAS-M Configuration Guide

Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 225
This command specifies how the state of a member port is signalled to the remote side when the status
corresponding to this member port has the standby value.
Default lacp
Parameters lacp — Specifies that LACP protocol is used to signal standby links of the LAG.
power-off — The laser of the standby links in the LAG are shutoff to indicate "standby" status. It allows
user to use LAG standby link feature without LACP, if the peer node does not support LACP.

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English