Ethernet Ring Commands
Page 232 7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide
This command adds a text description for the ring path. The no form of this command removes the text
description.
Default “”
Parameters string — Specifies the text description up to 160 characters in length.
rpl-end
Syntax rpl-end
no rpl-end
Context config>eth-ring>path
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command configures the G.8032 path as a ring protection link end. The ring should be declared as
either a RPL owner or RPL neighbor for this command to be allowed. Only path a or path b can be declared
an RPL-end.
The no form of this command sets the rpl-end to default no rpl-end.
Default no rpl-end
eth-cfm
Syntax eth-cfm
Context config>eth-ring>path
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command enables the context to configure ETH-CFM parameters.
mep
Syntax [no] mep mep-id domain md-index association ma-index
Context config>eth-ring>path>eth-cfm
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command provisions an 802.1ag maintenance endpoint (MEP).
The no form of the command reverts to the default values.
Parameters mep-id — Specifies the maintenance association end point identifier.
To Next Page
Loading...
Need help?
General
