Nokia 7210 SAS-M Configuration Guide

Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 231
propagate-topology-change
Syntax propagate-topology-change
[no] propagate-topology-change
Context config>eth-ring>sub-ring>interconnect
Description Platforms Supported: 7210 SAS-M (network mode), 7210 SAS-T (network mode), 7210 SAS-X, 7210
SAS-Mxp, 7210 SAS-Sx/S 1/10GE, 7210 SAS-Sx 10/100GE, 7210 SAS-R6 and 7210 SAS-R12.
This command configures the G.8032 sub-ring to propagate topology changes. From the sub-ring to the
major ring as specified in the G.8032 interconnection flush logic. This command is only valid on the sub-
ring and on the interconnection node. Since this command is only valid on a Sub-ring, a virtual link or non-
virtual link must be specified for this command to be configured. The command is blocked on major rings
(when both path a and b are specified on a ring).
The no form of this command sets propagate to the default
Default no propagate-topology-change
path
Syntax path {a | b} <portid> raps-tag <qtag [.qtag]>
[no] path {a | b}
Context config>eth-ring
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command assigns the ring (major or sub-ring) path to a port and defines the Ring APS tag. Rings
typically have two paths a and b.
The no form of this command removes the path a or b.
Default no path
Parameters raps-tag <qtag [.qtag]> — Specifies the VIDqtag.
Values Dot1q: 1—4094
Values QinQ: 1—4094.1—4094
description
Syntax description long-description-string
no description
Context config>eth-ring>path
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.

Nokia 7210 SAS-M Specifications

General

Brand	Nokia
Model	7210 SAS-M
Category	Cell Phone
Language	English