Ethernet Ring Commands
Page 230 7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide
Default no sub-ring
Parameters virtual-link — Specifies the interconnection is to a ring and a virtual link will be used.
non-virtual-link — Specifies the interconnection is to a ring or a VPLS instance and a virtual link will not be
used.
compatible-version
Syntax compatible-version version
[no] compatible-version
Context config>eth-ring
Description Platforms Supported: 7210 SAS-M, 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE,7210 SAS-Sx
10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T.
This command configures the backward compatibility logic for the Ethernet rings.
Default 2
Parameters version — Specifies the Ethernet ring version.
Values 1— 2
interconnect
Syntax interconnect {ring-id ring-index | vpls}
[no] interconnect
Context config>eth-ring>sub-ring>interconnect
Description Platforms Supported: 7210 SAS-M (network mode), 7210 SAS-X, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/
10GE,7210 SAS-Sx 10/100GE, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-T (network).
This command links the G.8032 sub-ring to a ring instance or to a VPLS instance. The ring instance must be
a complete ring with two paths but may itself be a sub-ring or a major ring (declared by its configuration on
another node) . When the interconnection is to another node, the sub-ring may have a virtual link or a non-
virtual-link. When the sub-ring has been configured with a non-virtual link, the sub ring may be alternatively
be connected to a VPLS service. This command is only valid on the interconnection node where a single
sub-ring port connects to a major ring or terminates on a VPLS service.
The no form of this command removes interconnect node.
Default no interconnect
Parameters ring-index — Specifies the ring index of the connection ring for this sub-ring on this node.
vpls — Specifies that the sub- ring is connected to the VPLS instance that contains the sub-ring SAP.
Values ring-index: 1—128
To Next Page
Loading...
Need help?
General
